Mts Fracture Template User Manual download pdf (Page 31)

DescriptionParameter

Specify the cycle intervals written to disk

during the precrack activity.

Store Every Nth Precrack

Cycle

Specify the amount of crack length change

that will cause data to be stored to disk.

Crack Size Change Store

Typically, operators will not store every cycle,

but will only store data when the crack grows

by a significant amount, such as 0.05 mm.

Specify the lower load limit for linear least

squares fit compliance used to determine

FCG Lower Least Squares

Fit Percentage

when to start saving data to disk. This

parameter is not used for FCG DCPD tests.

Specify the upper load limit for linear least

squares fit compliance used to determine

FCG Upper Least Squares

Fit Percentage

when to start saving data to disk. This

parameter is not used for FCG DCPD tests.

Specify the cycle intervals written to disk

during the test. Typically, this is more than

10,000.

FCG N Cycle Save

Test Termination Parameters

Test Termination Parameters

DescriptionParameter

Specify the crack size limit that, if exceeded,

ends the test.

FCG Final Crack Limit

Specify the crack growth rate limit that, if

exceeded, ends the test.

FCG Crack Growth Rate

Limit

Specify the number of times the FCG Crack

Growth Rate Limit can trip before the MPE

application ends the test.

Outside Crack Growth

Limits Allowed

Specify the maximum number of cycles to

run before the test ends. This parameter is

not used for FCG DCPD tests.

FCG Cycle Limit

MTS TestSuite | 31

Fatigue Crack Growth (FCG) Template

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 91 92

Comments to this Manuals

No comments